I ran on the computer what you asked for and this is its result:
==========================================================
r...@fmtest:/home/hezo# nm-tool
NetworkManager Tool
State: disconnected
- Device: eth0
-----------------------------------------------------------------
Type: Wired
Driver: tg3
State: unmanaged
Default: no
HW Address: 00:11:85:AF:32:82
Capabilities:
Carrier Detect: yes
Speed: 100 Mb/s
Wired Properties
Carrier: on
- Device: wlan0
----------------------------------------------------------------
Type: 802.11 WiFi
Driver: ar9170usb
State: disconnected
Default: no
HW Address: 94:0C:6D:E2:3C:E5
Capabilities:
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
pami: Infra, 00:26:ED:80:CC:6B, Freq 2437 MHz, Rate 54 Mb/s,
Strength 50 WPA2
==========================================================
r...@fmtest:/home/hezo# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
0.0.0.0 192.168.1.254 0.0.0.0 UG 0 0 0 eth0
==========================================================
/etc/network/interfaces:
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth0
iface eth0 inet dhcp
Greetings
hz
