On Sun, Aug 14, 2005 at 01:58:23PM +0200, Alfonso Cepeda Caballos wrote: > Comments/Problems: > > Configure network HW: My NIC is a built-int (Asus P5AD2-E Deluxe Mainboard) > Marvell 88E8053PCIE Gigabit LAN Controller and it is not detected (surfing > I found that it needs a propietary sky98lin controller, but the system > becomes inestable with it). I had to install another NIC (a DEC) that > works fine.
I believe a 2.6.11 or higher kernel should work with that version of the yukon. The driver in 2.6.8 only works with PCI versions, not PCI express which some newer boards now use. > Config network: In the DHCP phase it says that works fine but it cannot find > the gateway, it also says that you can continue the instalation but you only > can access to your LAN, and not internet. If you agree, the instalation > continues properly and on reboot you can download packages from internet > without any change. Strange, unless the DHCP server isn't configured to hand out a gateway. > Missing controllers: It does not detect my Intel HD Audio C-Media CMI 9880. > I had to recompile the kernel to activate it. It isn't just a matter if loading snd-intel8x0? Or is yet another device too new for 2.6.8? > Misdetection of graphics card: It does not detect the Ati Radeon RX700 Pro > 256 PCIE. It fails the X initialization. I had to reconfigure and use a vesa > controller. It is an ati, it is rather new, not surprising behaviour. > I found the instaler easier than before (it a perception, but maybe I am > more confident in debian now than when I did my last instalation 2 years > ago), but still very difficult in non-expert mode. The new installer does seem like an improvement for sure. Also much easier to customize and improve than the old one. Len Sorensen -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
