Hello, On Wed, Jun 30, 2010 at 06:58:53PM +0100, i...@comtek.co.uk wrote: > If I: > 'ifup eth0' > wait a few seconds until 'link becomes ready' > 'ifup eth0.3' > > then everything is fine. > > If I: > 'ifup eth0;ifup eth0.3' > > then I get a stack trace followed by the machine locking up (unless the > interfaces have been previously up. In that case doing 'rmmod tg3;modprobe > tg3;ifdown eth0;ifdown eth0.3' before ifup will cause it to panic).
It's obviously a kernel bug. I can't help you with that. I have to reassign it. The probable cause is the managing of up/down callbacks that vlan cannot handle and has NULL pointers assigned and that tg3 without checking calls. I can advise you to try to build your own kernel. 2.6.33 series is pretty stable *IFF* you leave out bridging vlans on bonds on bnx2 :-). (Those work again in 2.6.34 though with bonds being the culprit). > The machine is a HS20 (Type 8832) blade in an IBM bladecenter > and unfortunately I've not had any success with Serial Over Lan > so I can't currently get a backtrace. I will try to see if I > can adjust the resolution sufficiently to take a screenshot of > the whole backtrace though. ipmisol? It's pretty easy to set up. But your motherboard must be new enough. The linux based BMC's can handle ipmisol pretty well, but the older non linux based BMC really s...k at doing their job. BTW: I only have experience with DELL and supermicro ;-). > 00:00.0 Host bridge: Broadcom CMIC-LE Host Bridge (GC-LE chipset) (rev 33) > 00:00.1 Host bridge: Broadcom CMIC-LE Host Bridge (GC-LE chipset) > 00:00.2 Host bridge: Broadcom CMIC-LE Host Bridge (GC-LE chipset) > 00:01.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27) For a new BMC that should have been a: Matrox Graphics, Inc. MGA G200eW WPCM450 -- .signature not found -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
