Package: linux-image-2.6.26-1-686 Version: 2.6.26-13
Problems with Davicom Network Card, using DMFE and TULIP driver. maxim...@maximiliano:~$ sudo mii-diag Using the default interface 'eth0'. Basic registers of MII PHY #1: 3100 7809 0181 b841 01e1 0000 0000 0000. Basic mode control register 0x3100: Auto-negotiation enabled. Basic mode status register 0x7809 ... 7809. Link status: not established. End of basic transceiver information. maxim...@maximiliano:~$ sudo mii-tool eth0: negotiated 100baseTx-FD, link ok SIOCGMIIPHY on 'eth1' failed: Operation not supported > [ 2707.147623] Linux Tulip driver version 1.1.15-NAPI (Feb 27, 2007) > [ 2707.152789] tulip0: MII transceiver #1 config 1000 status 7809 > advertising 01e1. > [ 2707.158313] eth0: Davicom DM9102/DM9102A rev 64 at Port 0xac00, > 00:08:a1:82:31:32, IRQ 16. > [ 2716.000013] NETDEV WATCHDOG: eth0: transmit timed out > [ 2716.001374] 0000:01:08.0: tulip_stop_rxtx() failed (CSR5 0xfc108100 > CSR6 0x20e0000) > > [ 5404.000013] NETDEV WATCHDOG: eth0: transmit timed out > [ 5404.001372] 0000:01:08.0: tulip_stop_rxtx() failed (CSR5 0xfc120000 > CSR6 0x20e0000) > [ 5420.000016] NETDEV WATCHDOG: eth0: transmit timed out > [ 5420.001376] 0000:01:08.0: tulip_stop_rxtx() failed (CSR5 0xfc120000 > CSR6 0x20e0000) > > > 01:08.0 Ethernet controller: Davicom Semiconductor, Inc. 21x4x > DEC-Tulip compatible 10/100 Ethernet (rev 40) > Subsystem: Device 3030:5032 > Flags: bus master, medium devsel, latency 32, IRQ 16 > I/O ports at ac00 [size=256] > Memory at dfefe000 (32-bit, non-prefetchable) [size=256] > [virtual] Expansion ROM at dfd00000 [disabled] [size=256K] > Capabilities: [50] Power Management version 2 > Kernel driver in use: tulip > Kernel modules: dmfe, tulip > > > maxim...@maximiliano:~$ sudo tulip-diag -aem > tulip-diag.c:v2.18 11/12/2003 Donald Becker (bec...@scyld.com) > http://www.scyld.com/diag/index.html > Index #1: Found a Davicom DM9102 adapter at 0xac00. > * A potential Tulip chip has been found, but it appears to be active. > * Either shutdown the network, or use the '-f' flag to see all values. > Davicom DM9102 chip registers at 0xac00: > 0x00: de000000 ffffffff ffffffff 2ffed000 2ffed800 fc120000 020e2002 > ffffebef > Port selection is MII, half-duplex. > Transmit started, Receive started. > The Rx process state is 'Reading a Rx descriptor'. > The Tx process state is 'Reading a Tx descriptor'. > The transmit threshold is 128. > > cat /proc/interrupts > 16: 400 IO-APIC-fasteoi eth0 > > maxim...@maximiliano:~$ cat /proc/irq/16/spurious > count 3 > unhandled 0 > last_unhandled 0 ms > > Linux Maximiliano 2.6.26-1-686 #1 SMP Sat Jan 10 18:29:31 UTC 2009 > i686 GNU/Linux > > maxim...@maximiliano:~$ sudo modinfo tulip > filename: /lib/modules/2.6.26-1-686/kernel/drivers/net/tulip/tulip.ko > version: 1.1.15-NAPI > license: GPL > description: Digital 21*4* Tulip ethernet driver > author: The Linux Kernel Team > srcversion: D7C7C035C1D0941EE9D11CC > alias: pci:v00001414d00000002sv*sd*bc*sc*i* > alias: pci:v000014EAd0000AB08sv*sd*bc*sc*i* > alias: pci:v000010B7d00009300sv*sd*bc*sc*i* > alias: pci:v000017B3d0000AB08sv*sd*bc*sc*i* > alias: pci:v00001737d0000AB08sv*sd*bc*sc*i* > alias: pci:v00001737d0000AB09sv*sd*bc*sc*i* > alias: pci:v00001626d00008410sv*sd*bc*sc*i* > alias: pci:v000014F1d00001803sv*sd*bc*sc*i* > alias: pci:v00001186d00001591sv*sd*bc*sc*i* > alias: pci:v00001186d00001561sv*sd*bc*sc*i* > alias: pci:v00001186d00001541sv*sd*bc*sc*i* > alias: pci:v00001113d00009511sv*sd*bc*sc*i* > alias: pci:v00001113d00001217sv*sd*bc*sc*i* > alias: pci:v00001113d00001216sv*sd*bc*sc*i* > alias: pci:v00001282d00009102sv*sd*bc*sc*i* > alias: pci:v00001282d00009100sv*sd*bc*sc*i* > alias: pci:v00008086d00000039sv*sd*bc*sc*i* > alias: pci:v000011F6d00009881sv*sd*bc*sc*i* > alias: pci:v00001259d0000A120sv*sd*bc*sc*i* > alias: pci:v0000104Ad00002774sv*sd*bc*sc*i* > alias: pci:v0000104Ad00000981sv*sd*bc*sc*i* > alias: pci:v000013D1d0000AB08sv*sd*bc*sc*i* > alias: pci:v000013D1d0000AB03sv*sd*bc*sc*i* > alias: pci:v000013D1d0000AB02sv*sd*bc*sc*i* > alias: pci:v00001317d00009511sv*sd*bc*sc*i* > alias: pci:v00001317d00001985sv*sd*bc*sc*i* > alias: pci:v00001317d00000985sv*sd*bc*sc*i* > alias: pci:v00001317d00000981sv*sd*bc*sc*i* > alias: pci:v000011ADd0000C115sv*sd*bc*sc*i* > alias: pci:v0000125Bd00001400sv*sd*bc*sc*i* > alias: pci:v000010D9d00000531sv*sd*bc*sc*i* > alias: pci:v000010D9d00000512sv*sd*bc*sc*i* > alias: pci:v000011ADd00000002sv*sd*bc*sc*i* > alias: pci:v00001011d00000019sv*sd*bc*sc*i* > alias: pci:v00001011d00000009sv*sd*bc*sc*i* > depends: > vermagic: 2.6.26-1-686 SMP mod_unload modversions 686 > parm: tulip_debug:int > parm: max_interrupt_work:int > parm: rx_copybreak:int > parm: csr0:int > parm: options:array of int > parm: full_duplex:array of int > > maxim...@maximiliano:~$ sudo modinfo dmfe > filename: /lib/modules/2.6.26-1-686/kernel/drivers/net/tulip/dmfe.ko > version: 1.36.4 > license: GPL > description: Davicom DM910X fast ethernet driver > author: Sten Wang, sten_w...@davicom.com.tw > srcversion: 4D03B3DABA322C7AEB9BDFD > alias: pci:v00001282d00009009sv*sd*bc*sc*i* > alias: pci:v00001282d00009100sv*sd*bc*sc*i* > alias: pci:v00001282d00009102sv*sd*bc*sc*i* > alias: pci:v00001282d00009132sv*sd*bc*sc*i* > depends: > vermagic: 2.6.26-1-686 SMP mod_unload modversions 686 > parm: cr6set:int > parm: chkmode:byte > parm: HPNA_mode:byte > parm: HPNA_rx_cmd:byte > parm: HPNA_tx_cmd:byte > parm: HPNA_NoiseFloor:byte > parm: debug:Davicom DM9xxx enable debugging (0-1) (int) > parm: mode:Davicom DM9xxx: Bit 0: 10/100Mbps, bit 2: duplex, > bit 8: HomePNA (byte) > parm: SF_mode:Davicom DM9xxx special function (bit 0: VLAN, > bit 1 Flow Control, bit 2: TX pause packet) (byte) -- Maximiliano Augusto Castañón Araneda Santiago, Chile Linux user # 394821 -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
