On Sat, Jan 10, 2009 at 04:31:58PM +0000, Ben Hutchings wrote: > On Sat, 2009-01-10 at 14:05 +0100, Kurt Roeckx wrote: > > Package: ethtool > > Version: 6+20080913-1 > > > > Hi, > > > > On one of the interfaces where there is no cable plugged in, I see: > > Supported ports: [ TP ] > > Supported link modes: 10baseT/Half 10baseT/Full > > 100baseT/Half 100baseT/Full > > 1000baseT/Half 1000baseT/Full > > Supports auto-negotiation: Yes > > Advertised link modes: 10baseT/Half 10baseT/Full > > 100baseT/Half 100baseT/Full > > 1000baseT/Half 1000baseT/Full > > Advertised auto-negotiation: Yes > > Speed: Unknown! (0) > > Duplex: Half > > Port: Twisted Pair > > PHYAD: 1 > > Transceiver: internal > > Auto-negotiation: on > > Supports Wake-on: g > > Wake-on: g > > Current message level: 0x000000ff (255) > > Link detected: yes > > > > Notice that is says that a link is detected and the speed is 0. > > All this information comes straight from the driver. Please specify > which driver you are using and the kernel version (or driver version if > it's a separate module).
I'm currently running kernel 2.6.26-1-vserver-amd64 (Debian 2.6.26-10) >From dmesg: [ 4.673434] eth1: Tigon3 [partno(BCM95705C3) rev 3003 PHY(5705)] (PCI:33MHz:32-bit) 10/100/1000Base-T Ethernet 00:e0:81:63:cd:b3 [ 4.673439] eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[0] TSOcap[1] [ 4.673442] eth1: dma_rwctrl[763f0000] dma_mask[64-bit] lspci shows 01:0d.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5705 Gigabit Ethernet (rev 03) 01:0e.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5705 Gigabit Ethernet (rev 03) with -n: 01:0d.0 0200: 14e4:1653 (rev 03) 01:0e.0 0200: 14e4:1653 (rev 03) And the driver is probably "tg3". Kurt -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
