On Tue, Jan 17, 2006 at 11:25:23AM +0100, Konrad Korzeniowski wrote:
> Package: linux-source-2.6.12
> Version: 2.6.12-10
>
> I'm using Fujitsu-Siemens TX200 (one HT proc) machine with Serverworks
> CSB6 ide controler.
>
> System is setup on SCSI disk so I have some possibilities to experiment.
>
> lspci -vvv
> [...]
> 0000:00:0f.1 IDE interface: ServerWorks CSB6 RAID/IDE Controller (rev
> a0) (prog-if 8a [Master SecP PriP])
> Subsystem: Unknown device 1734:1012
> Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop-
> ParErr+ Stepping- SERR+ FastB2B-
> Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Latency: 64, Cache Line Size: 0x10 (64 bytes)
> Region 0: I/O ports at <ignored>
> Region 1: I/O ports at <ignored>
> Region 2: I/O ports at <ignored>
> Region 3: I/O ports at <ignored>
> Region 4: I/O ports at 1400 [size=16]
> [...]
>
> System is Sarge but I've installed package in question
> (linux-source-2.6.12) from testing.
>
> Debian-way custom compilation (make-kpkg) with predefined (nothing
> changed) config is smooth,
> but I cannot make serverworks module run.
> modprobe serverworks loads without error and I can see it listed with lsmod.
> But there is no :
> SvrWks CSB6: IDE controller at PCI slot 0000:00:0f.1
> SvrWks CSB6: chipset revision 160
> [...] in dmesg after module load, and I cannot access ide disks.
Does this error still occur with more recent kernel versions?
Cheers,
Moritz
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
