On 07/01/2008, Geert Stappers <[EMAIL PROTECTED]> wrote: > Op 06-01-2008 om 15:26 schreef Richard van der Veen: > > Again the kernel hangs with the message > > > > Linux......................................................................... > > BIOS data check successful > > Uncompressing Linux... OK, booting the kernel. > > PCI:BIOS BUG: MCFG area at f0000000 is not E820-reserved > > PCI: Not using MMCONFIG > > PCI: Failed to allocate mem resource #6:[EMAIL PROTECTED] for 0000:01:00.0 > > Loading , please wait.... > > ide0: I/O resource 0x3F6-0x3F6 not free. > > ide0: ports already in use, skipping probe > > ide1: I/O resource 0x376-0x376 not free. > > ide1: ports already in use, skipping probe > > mount: Mounting /dev/root on /root failed: No such device > > mount: Mounting /root/dev/ on /dev/.static/dev failed: No such file or > > directory > > mount: Mounting /sys on /root/sys failed: No such file or directory > > mount: Mounting /proc on /root/proc failed: No such file or directory > > Target filesystem doesn't have /sbin/init
Sorry if my information is not sufficient enough, but i am not sure if can pin-point exactly where the causes of my problem with using Debian are. Maybe it is a problem in the debian specific kernel. Anyway. Ubuntu, Mandrake, OpenSuse and Fedora do not give problems like this on the same hardware. > When I do `grep -i mount /var/log/syslog` on an installed system, > I don't get a line like: > > mount: Mounting /dev/root on /root failed: No such device > > What is '/dev/root'? > I would expect something like '/dev/sda1' Yes, Don't know. Why? ... > Why is it '/root'? > I would expect '/' Yes, me too, but /etc/lilo.conf says clearly that /dev/sdf1 is the partition which should be used as root partition. Which is recognized by debian as the 200GB ATA disk on which installed Debian. > I think^Wguess there is still some bootloader data on some disk > (the computer has several disks) and that data is not overwritten > during install. The computer boots from the wrong disk. > I have 3 disks in my computer. 2 ATA disks and 1 SATA disk. I can change to boot order from these disks in the BIOS. When my 200GB ATA disks boot i would like to boot Debian, When my 250 GB SATA disk boots (is first boot device) i can boot Ubuntu 7.10 and when my 320 GB ATA disk is first boot device i can boot OpenSuse 10.3 All disks have indeed a boot loader in their masterboot record. When i install debian from a testing-netinstall image on the 200 GB ATA disk i get the problems i described. Ubuntu on the same disc gives no problems, Fedora on the same disk also with the same boot order from the BIOS gives no problems, Mandrake also does not give any problems with the same disk order in the BIOS settings. Debian Etch doesn't even see my ATA disks, and booting with generic ata enabled gives a kernel OOPS. Only Debian gives a message about MMCONFIG (also during boot from the install CD) And i see this also back in the error messages after i installed with a hanging kernel. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
