On Mon, Oct 01, 2007 at 06:36:48AM +0100, Chris Austin wrote: > The memory upgrade went perfectly, and the Etch installer no longer > goes into low memory mode, but it still does not detect the hard > drives. > The Etch installer boots up, and I go through the steps to where it > starts a shell, and says that the hard disks will be in the /target > directory. But there is no /target directory.
At which step of the installer do you conclude that your hard drives are
not detected? Since Sarge, the installer may load the necessary drivers
not during the installer boot time, but later in the installation
process.
Which floppies are you exactly using?
--
Jérémy Bobbio .''`.
[EMAIL PROTECTED] : :Ⓐ : # apt-get install anarchism
`. `'`
`-
signature.asc
Description: Digital signature
