On Tue, 11 Sep 2007, Noèl Köthe wrote:
Am Dienstag, den 11.09.2007, 12:03 +0100 schrieb Reuben Thomas:
Hello,
The following manpages in your package appear to be UTF-8 encoded:
/usr/share/man/man1/mb2md.1.gz
According to Colin Watson, "With some exceptions for Far Eastern
languages, manual pages should not at present be encoded using UTF-8.
As such, it's reasonable to file bugs against packages attempting to
use UTF-8 where it is not yet supported."
etch supports utf8 by default
Not (according to Colin) in man pages, except in certain locales. Viewing a
UTF-8 encoded man page with man (using less as the pager) in a UTF-8 locale,
in xterm, does not work: the UTF-8 characters are not output correctly. For
example, with LANG=en_GB.UTF-8.
If I use an 8-bit locale, the output is correct, but that's not exactly
"supporting UTF-8"!
--
http://rrt.sc3d.org/ | perfect, a. dead
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
