Package: installation-reports Version: RC3 from http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/ia64/rc3/sarge-ia64-netinst.iso
The initial bootloader works and gives me a menu listing kernels. I've tried 2.6 (VGA), 2.4 (VGA) and 2.6 (9600 serial). All grab the kernel and initrd. Once the kernel gets to ... ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 19 (level, low) -> IRQ 52 GSI 56 (level, low) -> CPU 1 (0x0300) vector 53 ACPI: PCI interrupt 0000:01:0f.0[A] -> GSI 56 (level, low) -> IRQ 53 GSI 57 (level, low) -> CPU 0 (0x0000) vector 54 ACPI: PCI interrupt 0000:02:0f.0[A] -> GSI 57 (level, low) -> IRQ 54 GSI 55 (level, low) -> CPU 1 (0x0300) vector 55 ACPI: PCI interrupt 0000:03:00.0[A] -> GSI 55 (level, low) -> IRQ 55 perfmon: version 2.0 IRQ 238 perfmon: Itanium PMU detected, 14 PMCs, 18 PMDs, 4 counters (32 bits) in all cases it stops dead and will not respond any further. It sounds like the hardware is resetting at this point - the IDE floppy and the CD drive both make a churning noise similar to that at initial POST, and the VGA display blanks. An old woody install CD boots just fine on the same hardware. The machine in question used to be caballero - an HP workstation i2000, 2 800 MHz CPUs and 2GB of RAM. Let me know if/how I can help with debugging this. -- Steve McIntyre, Cambridge, UK. [EMAIL PROTECTED] "I suspect most samba developers are already technically insane... Of course, since many of them are Australians, you can't tell." -- Linus Torvalds -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
