On Sat, 9 Dec 2006 17:29:03 +0100 Holger Wansing wrote:
> On Sat, 09 Dec 2006 16:02:03 +0100 Liniger Simon wrote:
> > sorry the programm doesen't work the normal mode and the epert
> > mode are both uncompatible with my system.
> > --
>
> We need more informations on this "incompatibility" to solve
> this:
> what happens exactly or what doesn't happen?
>
> In case that your english is a problem here, feel free to mail
> me directly in german.
Well, I had several mails with Simon to get the needed info,
unfortunately he didn't answer anymore to the question, if he
used rc1 images or daily builds. So it leaves open, if kernel
2.6.17 or 2.6.18 was used; but here is what happens:
Machine is a Sun blade 100 (sparc machine).
Sarge r4 installation image boots fine, but then lacks cd detection
(cd could not be mounted).
Etch images (rc1 or daily builds ~ 20061209, not sure) boot to the
d-i boot prompt and after pressing Enter:
booting linux......
then machine hangs.
Could the sparc porters / kernel guys look into this?
(Ubuntu 6.06 for sparc works fine on that machine, while Ubuntu 6.10
also fails.)
Hardware info:
[EMAIL PROTECTED]:~# lspci -vv
0000:00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIe
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr+ Stepping- SERR+ FastB2B- Status: Cap- 66MHz+ UDF- FastB2B+
ParErr- DEVSEL=medium >TAbort+ <TAbort- <MAbort+ >SERR- <PERR-
Latency: 40
0000:00:03.0 Non-VGA unclassified device: ALi Corporation M7101
Power Management Controller [PMU] Control: I/O- Mem- BusMaster-
SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
0000:00:05.0 PCI bridge: Digital Equipment Corporation DECchip
21152 (rev 03) (prog-if 00 [Normal decode]) Control: I/O+ Mem+
BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR-
FastB2B- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64, Cache Line Size: 0x10 (64
>bytes) Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
BridgeCtl: Parity- SERR- NoISA- VGA- MAbort- >Reset-
FastB2B- Capabilities: [dc] Power Management version 1
Flags: PMEClk- DSI- D1- D2- AuxCurrent=220mA PME
(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0
PME- Bridge: PM- B3+
0000:00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge
[Aladdin IV] Subsystem: ALi Corporation ALI M1533 Aladdin IV ISA
Bridge Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B-
ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0 Capabilities: [a0] Power Management version 1
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME
(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0
PME-
0000:00:08.0 Multimedia audio controller: ALi Corporation M5451 PCI
AC-Link Controller Audio Device (rev 01) Subsystem: ALi Corporation
HP Compaq nc4010 (DY885AA#ABN) Control: I/O+ Mem+ BusMaster+
SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- Latency: 64 (500ns min, 6000ns max)
Interrupt: pin A routed to IRQ 7616736 Region 0: I/O ports at
2000900 [size=256] Region 1: Memory at 000001ff00424000 (32-bit,
non-prefetchable) [size=4K] Capabilities: [dc] Power Management
version 2 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2
+,D3hot+,D3cold+) Status: D0 PME-Enable- DSel=0 DScale=0 PME-
0000:00:0c.0 Bridge: Sun Microsystems Computer Corp. RIO EBUS (rev
01) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr+ Stepping- SERR+ FastB2B- Status: Cap- 66MHz- UDF- FastB2B+
ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (2500ns min, 6250ns max), Cache Line Size: 0x10 (64
bytes) BIST result: 00 Region 0: Memory at 000001ff04000000
(32-bit, non-prefetchable) [size=16M] Region 1: Memory at
000001ff01800000 (32-bit, non-prefetchable) [size=8M] Expansion ROM
at 0000000005000000 [disabled] [size=16M]
0000:00:0c.1 Ethernet controller: Sun Microsystems Computer Corp.
RIO GEM (rev 01) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV-
VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66MHz- UDF-
FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR-
<PERR- Latency: 64 (2500ns min, 1250ns max), Cache Line Size: 0x10
(64 bytes) Interrupt: pin ? routed to IRQ 7615808 BIST result: 00
Region 0: Memory at 000001ff00400000 (32-bit,
non-prefetchable) [size=128K] Expansion ROM at 0000000000800000
[disabled] [size=16M]
0000:00:0c.2 FireWire (IEEE 1394): Sun Microsystems Computer Corp.
RIO 1394 (rev 01) (prog-if 10 [OHCI]) Control: I/O- Mem+ BusMaster+
SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- Latency: 64 (2500ns min, 1250ns
max), Cache Line Size: 0x10 (64 bytes) Interrupt: pin ? routed to
IRQ 7616512 BIST result: 00 Region 0: Memory at 000001ff00420000
(32-bit, non-prefetchable) [size=2K] Region 1: Memory at
000001ff00422000 (32-bit, non-prefetchable) [size=2K] Expansion ROM
at 0000000006000000 [disabled] [size=16M]
0000:00:0c.3 USB Controller: Sun Microsystems Computer Corp. RIO
USB (rev 01) (prog-if 10 [OHCI]) Control: I/O- Mem+ BusMaster+
SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort+ <MAbort- >SERR- <PERR- Latency: 64 (2500ns min, 1250ns
max), Cache Line Size: 0x10 (64 bytes) Interrupt: pin ? routed to
IRQ 7616768 BIST result: 00 Region 0: Memory at 000001ff02000000
(32-bit, non-prefetchable) [size=32K] Expansion ROM at
0000000007000000 [disabled] [size=16M]
0000:00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c3)
(prog-if ff) Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV-
VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF-
FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR-
<PERR- Latency: 64 (500ns min, 1000ns max) Interrupt: pin A routed
to IRQ 7616000 Region 0: I/O ports at 2000a00 [size=8]
Region 1: I/O ports at 2000a18 [size=4]
Region 2: I/O ports at 2000a10 [size=8]
Region 3: I/O ports at 2000a08 [size=4]
Region 4: I/O ports at 2000a20 [size=16]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME
(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0
PME-
0000:00:13.0 VGA compatible controller: ATI Technologies Inc Rage
XL (rev 27) (prog-if 00 [VGA]) Control: I/O+ Mem+ BusMaster+
SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- Latency: 64 (2000ns min), Cache
Line Size: 0x10 (64 bytes) Interrupt: pin A routed to IRQ 7616096
Region 0: Memory at 000001ff03000000 (32-bit, non-prefetchable)
[size=16M] Region 1: I/O ports at 2000b00 [size=256] Region 2:
Memory at 000001ff00426000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at 0000000000440000 [disabled] [size=128K]
Capabilities: [5c] Power Management version 2 Flags: PMEClk- DSI- D1
+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0
PME-Enable- DSel=0 DScale=0 PME-
[EMAIL PROTECTED]:~$ lspci -nn
0000:00:00.0 0600: 108e:a001
0000:00:03.0 0000: 10b9:7101
0000:00:05.0 0604: 1011:0024 (rev 03)
0000:00:07.0 0601: 10b9:1533
0000:00:08.0 0401: 10b9:5451 (rev 01)
0000:00:0c.0 0680: 108e:1100 (rev 01)
0000:00:0c.1 0200: 108e:1101 (rev 01)
0000:00:0c.2 0c00: 108e:1102 (rev 01)
0000:00:0c.3 0c03: 108e:1103 (rev 01)
0000:00:0d.0 0101: 10b9:5229 (rev c3)
0000:00:13.0 0300: 1002:4752 (rev 27)
--
Kind regards
Holger
==============================================================
Created with Sylpheed 2.2.2
under Debian GNU/LINUX 3.1 »Sarge«
http://counter.li.org/, Registered LinuxUser #311290
Spamfiltering by bogofilter.sourceforge.net
=============================================================
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
