A quick follow up (that was unsuccessfully sent yesterday):
After sending the report, my wifi network (Network A - "Starbucks")
stopped working. With "stopped working" I mean that my machine lost the
association with the AP. I made several tries to associate to the same
network again, without success. This I what I could see on dmesg:
...
[22444.808389] wlp2s0: authenticate with ee:55:b8:81:8b:af (local
address=04:7b:cb:b7:89:ca)
[22444.808402] wlp2s0: send auth to ee:55:b8:81:8b:af (try 1/3)
[22444.813991] wlp2s0: authenticated
[22444.816393] wlp2s0: associate with ee:55:b8:81:8b:af (try 1/3)
[22444.828044] wlp2s0: RX AssocResp from ee:55:b8:81:8b:af (capab=0x1501
status=0 aid=69)
[22444.847942] wlp2s0: associated
[22444.847997] wlp2s0: Limiting TX power to 23 (23 - 0) dBm as advertised by
ee:55:b8:81:8b:af
[22476.256989] wlp2s0: deauthenticating from ee:55:b8:81:8b:af by local choice
(Reason: 3=DEAUTH_LEAVING)
[22476.743627] wlp2s0: authenticate with ee:55:b8:81:8b:af (local
address=04:7b:cb:b7:89:ca)
[22476.743636] wlp2s0: send auth to ee:55:b8:81:8b:af (try 1/3)
[22476.748763] wlp2s0: authenticated
[22476.752418] wlp2s0: associate with ee:55:b8:81:8b:af (try 1/3)
[22476.764521] wlp2s0: RX AssocResp from ee:55:b8:81:8b:af (capab=0x1501
status=0 aid=69)
[22476.781659] wlp2s0: associated
[22476.790502] wlp2s0: Limiting TX power to 23 (23 - 0) dBm as advertised by
ee:55:b8:81:8b:af
[22522.001334] wlp2s0: deauthenticating from ee:55:b8:81:8b:af by local choice
(Reason: 3=DEAUTH_LEAVING)
[22808.678547] wlp2s0: authenticate with ee:55:b8:81:8b:af (local
address=04:7b:cb:b7:89:ca)
[22808.678556] wlp2s0: send auth to ee:55:b8:81:8b:af (try 1/3)
[22808.685713] wlp2s0: authenticated
[22808.688398] wlp2s0: associate with ee:55:b8:81:8b:af (try 1/3)
[22808.704101] wlp2s0: RX AssocResp from ee:55:b8:81:8b:af (capab=0x1501
status=0 aid=77)
[22808.750002] wlp2s0: associated
[22808.750082] wlp2s0: Limiting TX power to 23 (23 - 0) dBm as advertised by
ee:55:b8:81:8b:af
I switched to another wifi network (Network B) that my machine get
associated to, but the network wasn't actually usable (although, it was
usable from another device). My machine got an IPv4 address and route,
but it was not able to reach the outside network.
3: wlp2s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP
group default qlen 1000
link/ether 04:7b:cb:b7:89:ca brd ff:ff:ff:ff:ff:ff
altname wlx047bcbb789ca
inet 192.168.33.84/24 brd 192.168.33.255 scope global dynamic noprefixroute
wlp2s0
valid_lft 3464sec preferred_lft 3464sec
inet6 fe80::f74d:efc9:5cf4:6a7e/64 scope link noprefixroute
valid_lft forever preferred_lft forever
ip r | grep wlp2s0
default via 192.168.33.63 dev wlp2s0 proto dhcp src 192.168.33.84 metric 600
192.168.33.0/24 dev wlp2s0 proto kernel scope link src 192.168.33.84 metric 600
ping -c 4 1.1.1.1:
PING 1.1.1.1 (1.1.1.1) 56(84) bytes of data.
>From 192.168.33.84 icmp_seq=1 Destination Host Unreachable
>From 192.168.33.84 icmp_seq=2 Destination Host Unreachable
>From 192.168.33.84 icmp_seq=3 Destination Host Unreachable
>From 192.168.33.84 icmp_seq=4 Destination Host Unreachable
--- 1.1.1.1 ping statistics ---
4 packets transmitted, 0 received, +4 errors, 100% packet loss, time 3055ms
pipe 3
FWIW, this is from network A, after getting associated again, but
networking was not usable either:
iwconfig wlp2s0
wlp2s0 IEEE 802.11 ESSID:"Starbucks"
Mode:Managed Frequency:5.18 GHz Access Point: EE:55:B8:81:8B:AF
Bit Rate=432.3 Mb/s Tx-Power=15 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=46/70 Signal level=-64 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
