Hello, a new release of chan-capi is out (changelog follows). It seems like it compiles also for asterisk 1.2. A package would be great :)
Alex Changes: chan_capi-cm-0.6.1 ------------------ - fixed setting of redirecting number rdnis instead of cid. - allow setting a callerid in the dial() command without changing the original channel callerid. - added config 'defaultcid' to set a default caller id which will be used if dial option 'd' is specified. - moved ast_softhangup() out of interface lock - use correct mutex_init call for interface lock - when 'o' option is used for overlap dialing, don't send any digits with the CONNECT_REQ. This gives better progress together with 'b'. - create a pseudo channel for each interface for incoming signalling without B-channel. - added channel locks - fixed capi init order (thanks to Hans Petter Selasky) - fixed did handling - set RDNIS if redirecting number was received. - simplified call to ast_exists_extension() - when check for valid extension, check the callerid as well - changed call-waiting and deflect handling in CONNECT_IND - use 'immediate' config in MSN mode, if pbx shall be started on CONNECT_IND and shall not wait until SETUP/SENDING-COMPLETE was received. Since info like REDIRECTINGNUMBER will come after CONNECT_IND, this may be lost then. But for some drivers/telcos/pbx, this setting is needed. - fix start of line interconnect in old mode. - start early-b3 on PROCEEDING too. - don't send audio data, if in fax receive mode - disconnect on finished fax immediately - don't run through gain list, if gain is 1.0. - use correct A-law idle value. - removed old example from capi.conf -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
