On 05/01/13 20:53, Jeffrey Sheinberg wrote: > Here is the tail of the installer log: > > Dec 28 12:49:56 finish-install: info: Running > /usr/lib/finish-install.d/20final- message > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/30hw-det ect > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/50config-target-network > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/55netcfg-network-manager > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/60cleanup > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/65partman-md > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/90base-installer > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/90console > Dec 28 12:50:13 finish-install: info: Running > /usr/lib/finish-install.d/94save-logs
Did you retrieve that log after reboot? If so, there was probably a little more happened after the log was saved... For comparison, here is my own log using today's wheezy d-i installer image - I redirected this over a serial console though to make sure I got all of it: > Jan 5 22:38:11 finish-install: info: Running > /usr/lib/finish-install.d/90base-installer > Jan 5 22:38:12 finish-install: info: Running > /usr/lib/finish-install.d/90console > Jan 5 22:38:12 finish-install: info: Running > /usr/lib/finish-install.d/94save-logs > Jan 5 22:38:34 finish-install: info: Running > /usr/lib/finish-install.d/95umount > Jan 5 22:38:40 finish-install: umount: can't umount /dev: Device or resource > busy > Jan 5 22:38:40 finish-install: umount: can't umount /dev: Device or resource > busy > Jan 5 22:38:40 finish-install: umount: can't umount /: Invalid argument > Jan 5 22:38:40 finish-install: info: Running > /usr/lib/finish-install.d/97release-dhcp-lease So in my case release-dhcp-lease was actually run, after save-logs. If you have a serial console, you can probably syslog on it by dropping to a shell and: $ sed -ie s/tty3/ttyS0/ /etc/inittab && kill -HUP 1 Or you can even set preseed/early_command to that command line (putting the whole thing in quotes; you need to send SIGHUP to init to reload the inittab). Regards, -- Steven Chamberlain ste...@pyro.eu.org -- To UNSUBSCRIBE, email to debian-bugs-dist-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
