Package: kernel-image-2.4.27-2-k6
Version: 2.4.27-7
Severity: normal
After "NET4: Unix domain sockets 1.0/SMP for Linux NET4.0." this kernel
spontaneously reboots. The next line in the 2.4.22-1-k6 kernel bootup is
"Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4"
>From /proc/isapnp:
Card 1 'AXE2201:Ethernet PnP ISA Card /S' PnP version 1.0
Logical device 0 'AXE2201:Unknown'
Supported registers 0x2
Compatible device PNP80d6
Device is active
Active port 0x240
Active IRQ 5 [0x2]
Resources 0
Priority preferred
Port 0x240-0x380, align 0x1f, size 0x20, 10-bit address decoding
IRQ 3,5,2/9,10,11,12,15 High-Edge
>From /proc/pci:
Bus 0, device 11, function 0:
IDE interface: ALi Corporation M5229 IDE (rev 32).
IRQ 10.
Master Capable. Latency=64. Min Gnt=2.Max Lat=4.
I/O at 0xf000 [0xf00f].
>From /proc/ide/ali:
Ali M15x3 Chipset.
------------------
PCI Clock: 33.
CD_ROM FIFO:No , CD_ROM DMA:Yes
FIFO Status: contains 0 Words, runs.
-------------------primary channel-------------------secondary channel---------
channel status: On On
both channels togth: Yes Yes
Channel state: OK OK
Add. Setup Timing: 1T 2T
Command Act. Count: 3T 3T
Command Rec. Count: 3T 3T
----------------drive0-----------drive1------------drive0-----------drive1------
DMA enabled: Yes Yes No No
FIFO threshold: 13 Words 13 Words 12 Words 13 Words
FIFO mode: FIFO On FIFO On FIFO Off FIFO On
Dt RW act. Cnt 3T 3T 3T 8T
Dt RW rec. Cnt 1T 1T 3T 16T
-----------------------------------UDMA Timings--------------------------------
UDMA: No No No No
UDMA timings: 1.5T 1.5T 1.5T 1.5T
-- System Information:
Debian Release: 3.1
APT prefers testing
APT policy: (800, 'testing'), (500, 'unstable')
Architecture: i386 (i586)
Kernel: Linux 2.4.22-1-k6
Locale: LANG=C, LC_CTYPE=C (charmap=ANSI_X3.4-1968)
Versions of packages kernel-image-2.4.27-2-k6 depends on:
ii coreutils [fileutils] 5.2.1-2 The GNU core utilities
ii fileutils 5.2.1-2 The GNU file management utilities
ii initrd-tools 0.1.76 tools to create initrd image for p
ii modutils 2.4.26-1.2 Linux module utilities
-- no debconf information
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
