> > Theses 2 leds are provided by the iop gpios but the others are > provided > > by the f75111 driver. Check that you have enabled it in your kernel > > configuration (iirc you'll find the option to enable this module in > the > > i2c menu). > Ok, I found : <M> Fintec F75111 chip , I selected it and I am going > to > recompile the kernel and test the new zImage: I will let you informed > about progress ! > I added this module and now I can modprobe it, which autoload led-class but nothing appear undel /sys/class/leds
storage01:~# lsmod Module Size Used by f75111 6720 0 led_class 3876 1 f75111 dm_snapshot 15712 0 dm_mirror 24960 0 dm_mod 51876 2 dm_snapshot,dm_mirror storage01:~# dir /sys/class/leds/ total 0 drwxr-xr-x 2 root root 0 Nov 19 16:53 . drwxr-xr-x 22 root root 0 Nov 19 16:53 .. of course, modprobing leds-gpio: storage01:~# modprobe leds-gpio Registered led device: status:amber Registered led device: HD:green storage01:~# dir /sys/class/leds/ total 0 drwxr-xr-x 4 root root 0 Nov 19 16:55 . drwxr-xr-x 22 root root 0 Nov 19 16:53 .. drwxr-xr-x 3 root root 0 Nov 19 16:55 HD:green drwxr-xr-x 3 root root 0 Nov 19 16:55 status:amber as was before. What else can I check ? > > > --- > > > 2nd question: I have no rtc inside; I setup in order to get the > time > > from an external time server, > > > and it is ok; Anyway I would like to know if this system (ss4000e) > > actually support rtc, and > > > what can I try to do to enable it. I have non /dev/rtc0 nor any > > module compiled about rtc > > > > Look for rs5c372 in your kernel configuration > > > I found : <*> Ricoh RS5C372A/B, RV5C386, RV5C387A already > selected. > It is built-in and not modular....Is it OK ? > in dmesg, about rtc, I can read: > > ... > RPC: Registered tcp transport module. > XScale DSP coprocessor detected. > drivers/rtc/hctosys.c: unable to open rtc device (rtc0) > md: Autodetecting RAID arrays. > .... > > > > > > > Arnaud > > thanks, > Andrea > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact > [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
