Hi. I used the installer few times on the same device (different disks). I had problems with the disks, but I guess this was unrelated to the installer. The debian installer always worked flowlessly for me...
I dind't initialized my disks with the original installer. I zapped it way and flashed the debian installer directly. good luck. :) p On Fri, Sep 26, 2008 at 06:56:04PM +0200, Morten O. Hansen wrote: > Hi > > Im not sure if I should post this here, or on the debian-boot mailing > list, so if this is wrong, please tell me. > > I have a QNAP TS-209 which i bought today (with 2x 1tb seagate > barracuda disks). And i had planned to install debian linux on it > (with instructions from > http://www.cyrius.com/debian/orion/qnap/ts-209/install.html). > > I followed the instructions, and flashed it with the files that was linked: > http://people.debian.org/~joeyh/d-i/armel/images/daily/orion5x/netboot/qnap/ts-209/flash-debian > http://people.debian.org/~joeyh/d-i/armel/images/daily/orion5x/netboot/qnap/ts-209/initrd.gz > http://people.debian.org/~joeyh/d-i/armel/images/daily/orion5x/netboot/qnap/ts-209/kernel > > And it told me to reboot. After i did this, nothing more really > happend. The status icon is blinking, which is (according to the > manual): > Blink in green: Hard disk not detected; Hard disk not initialized. > > But both HDD lights are correct, so i guess its a problem with the > installer? I get the same blinking status led if i boot without any > disks. > > So I guess tomorrow I will have to go out and buy a serial connector > and reflash with the original firmware (no problem, i knew this could > happen). > > Now, what im wondering is.. what did i do wrong? was i just unlucky > with the day i downloaded the installer and should probably wait a > couple of days before downloading a new image? > > Any ideas/comments would be appreciated.. > > Thank you, > Morten > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
