Re: Programming problem with POSIX threads and stdout

[Mauro Brunato]

Thanks, Brian! Actually, I had seen that posting, but I missed the fact that 
the third reply was from Faylor, and not from the original poster, who said 
that the problem had been fixed *after* the last stable release.

I'll go get a recent snapshot of the DLL.
Thank you again,
 Mauro.
----- Original Message ----- 
From: "Brian Ford" <[EMAIL PROTECTED]>
To: "Mauro Brunato" <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Wednesday, September 29, 2004 6:09 PM
Subject: Re: Programming problem with POSIX threads and stdout


On Wed, 29 Sep 2004, Mauro Brunato wrote:
The following has probably already been noticed by someone,
Yup.
but I could not find any reference (at least, comprehensible to me), so
I apologize if my problem has already been taken care of.
How 'bout this thread?:
http://cygwin.com/ml/cygwin/2004-09/msg01292.html
Consider the following code:
[snip]
I also tried putting debug or optimization flags (-g, -O, -O2) and put an
explicit "-lpthread" at the end, with no luck.
-lpthread is not needed on Cygwin.  The pthreads code is part of the
cygwin dll.
--
Brian Ford
Senior Realtime Software Engineer
VITAL - Visual Simulation Systems
FlightSafety International
the best safety device in any aircraft is a well-trained pilot... 

--
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple
Problem reports:       http://cygwin.com/problems.html
Documentation:         http://cygwin.com/docs.html
FAQ:                   http://cygwin.com/faq/