Hi Everyone,
I am currently working on a custom Denverton board similar to the Intel Harcuvar board. CAR is working and the ROM stage is executing. There should be console output on UART0, but it does not appear to be initializing. There is a logic analyzer connected directly to the SOC UART pins and the internal pull up can be seen working during hard strap sampling, but after strap sampling TX goes low and stays low. I have tried configuring it as both HSUART and legacy UART with early console init both disabled and enabled and nothing has worked. Is there anything that could be preventing the UART from initializing? Thanks Balaji
_______________________________________________ coreboot mailing list -- [email protected] To unsubscribe send an email to [email protected]
