Hi,
I have unit tests configured for CDash submissions. Submissions do work if I
issue in sequence TWO commands which go pretty much like this:
# configure the build system
${CMAKE_ROOT}${CMAKE_BINDIR}/cmake .
# build tests
make clean ; make
# run tests
${CMAKE_ROOT}${CMAKE_BINDIR}/ctest
However, when doing that CDash shows useful results only for the test phase -
build info is missing and configure info shows only 3 lines despite removal of
CMakeCache.txt.
So I attepmted using the build-and-test option. I would expect this to work:
/vob/tetra/tools/CMake/bin_linux_x86_64/ctest -D Experimental --build-and-test
. . --build-generator 'Unix Makefiles' --build-makeprogram `which clearmake`
but it only builds and tests --- '-D' option seems to be ignored.
I also tried this:
/vob/tetra/tools/CMake/bin_linux_x86_64/ctest --build-and-test . .
--build-generator 'Unix Makefiles' --build-makeprogram `which clearmake`
--test-command ./test_command.sh
where test_command.sh executes 'ctest -D Experimental' but although it
submission is achieved the CDash contents is the same as with the original two
commands.
So my question is how to achieve CDash submission with 'scratch' configure info
(just as if cmake was invoked on clean environment), build info (compilation
warnings and such) and test results by issueing single command ?
Thanks for help,
Wojtek
----------------------------------------------
Księgowa radzi: Jak załozyć firmę w 15 minut?
http://linkint.pl/f2842
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the CMake FAQ at:
http://www.cmake.org/Wiki/CMake_FAQ
Follow this link to subscribe/unsubscribe:
http://www.cmake.org/mailman/listinfo/cmake
