Before I replied, I wanted to renew my confidence and do a small test
in a lab environment. I also created a k4m2 pool with host as
failure-domain, started to write data chunks into it in a while loop
and then marked three of the OSDs "out" simultaneously. After a few
seconds of repeering backfill kicks in, I/O to the pool continues
without interruption. So yeah, I also think it's safe to mark them out
at the same time.
Zitat von Anthony D'Atri <[email protected]>:
It’s context-dependent, where the OSDs are. If they’re all in the
same failure domain it’s safe, if you have capacity to recover into.
Across failure domains, usually not.
The reason I asked is that several months back I got a off list reply from
a frequent poster on this list, that setting 3 OSDs out at the same
time could
give me incomplete PGs as a result.
But a least now I have 2 saying is OK and 1 saying it's not so thank you
Alexander and Janne.
--
Kai Stian Olstad
_______________________________________________
ceph-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
ceph-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
ceph-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
