To be honest, we print at work from PETG, ASA and ABS without enclosure and without dryer (Prusa MK3). It was not much better with the enclosure... Way more influence is by the mode (e.g. adding stress relief slots, mouse ears to help with adhesion etc.)
Btw. you should probably take this discussion to brmlab@ On 31. 03. 23 14:27, Vasiliy Chernov via Rada wrote:
Hi Everyone, I found today this box for 3D printer: https://www.majkl3d.cz/p/creality-kryt-na-3d-tiskarnu It seems like a great solution for our printer. Relatively cheap and will allow to print different types of filament (not only PLA as it is today). Also, I can order filament dryer. It is a bit more expensive on that website than on Aliexpress. So, if everybody is fine, we can order either just that one, or both. What do you think? Cheers! _______________________________________________ Rada mailing list [email protected] https://brmlab.cz/cgi-bin/mailman/listinfo/rada
-- Jan Hrach | https://jenda.hrach.eu/ _______________________________________________ Brmlab mailing list [email protected] https://brmlab.cz/cgi-bin/mailman/listinfo/brmlab
