Thank you so much for your help! I does the trick. You are great! Mike On 17-01-19 18:23:44, Tijmen de Mes wrote: > Hi, > > If you use sip2sip.info as proxy setting, you should make sure that it uses > DNS SRV. > > In a cisco 303 I have this setting in the advanced mode in the section 'proxy > and registration'. > DNS SRV Auto Prefix and Use OB Proxy In Dialog are also enabled. > > The sip port you configured is the local port of the Device. It is not the > server port. You should leave it on > 5060 which is the default. > > Best regards, > > Tijmen de Mes > — > AG Projects > > > On 19 jan. 2017, at 13:55, Michael Nagie <[email protected]> wrote: > > > > Hello, > > > > I stuck and I need some help. I bought a Cisco SPA504G in the end and > > I've been configuring SIP2SIP for about 5 hours but I still can't figure > > out what is wrong. > > > > I tried to follow the description: > > http://sip2sip.info/settings/ > > > > But I'm failed. > > > > My settings right now are: > > > > Line Enable: yes > > Sip Transport: TLS > > Sip Port: 443 > > Proxy: sip2sip.info > > Register Expires: 3600 > > Display name, User ID and Auth ID are my username without @sip2sip.info. > > Password is my passwd. > > And currently the prefered codec is g711u, but I don't think that really > > matters. > > > > So I get: > > Line SIP2SIP > > Failed (Not Reachable) > > > > If I change the settings to SIP Transport to UDP 5060 then my line > > button blinks: > > Not Registered(?) > > After a while 'Failed (No response)' then it changes to > > 'Not Registered (No response)' > > > > Thanks in advance! > > _______________________________________________ > > Blink mailing list > > [email protected] > > http://lists.ag-projects.com/mailman/listinfo/blink >
> _______________________________________________ > Blink mailing list > [email protected] > http://lists.ag-projects.com/mailman/listinfo/blink _______________________________________________ Blink mailing list [email protected] http://lists.ag-projects.com/mailman/listinfo/blink
