On Tue, Sep 18, 2018 at 08:38:56AM +0000, Kenth Eriksson wrote:
> Hi!
>
> I'm using BIRD 2.0.2 and have trouble with static routes that gets stuck in
> dormant state. It looks as the problem happens if the static route is pushed
> into BIRD config before the interface exists. BIRD detects when interfaces go
> up and down, but misses when interfaces are added. The only way I have found
> to kick BIRD out if this state is to issue another configure command after
> the interface exists.
>
> Reproducing this is very easy, simply add a static route over a sub-interface
> that is not yet created, this leaves the route in dormant state
Hi
Works for me:
# ./birdc -l show static static4
BIRD v2.0.2-40-g0ed3129f-x ready.
10.10.10.0/24
dev ve0.10 (dormant)
# ./birdc -l show route 10.10.10.0/24
BIRD v2.0.2-40-g0ed3129f-x ready.
Network not found
# vconfig add ve0 10
Added VLAN with VID == 10 to IF -:ve0:-
# ifconfig ve0.10 up
# ./birdc -l show static static4
BIRD v2.0.2-40-g0ed3129f-x ready.
10.10.10.0/24
dev ve0.10
# ./birdc -l show route 10.10.10.0/24
BIRD v2.0.2-40-g0ed3129f-x ready.
Table master4:
10.10.10.0/24 unicast [static4 14:21:18.093] * (200)
dev ve0.10
Although i am trying it on current int-new Git branch, i don't see any
relevant changes since v2.0.2
Could you try it with enabled 'debug all' for static and device protocols
and report the logs?
--
Elen sila lumenn' omentielvo
Ondrej 'Santiago' Zajicek (email: [email protected])
OpenPGP encrypted e-mails preferred (KeyID 0x11DEADC3, wwwkeys.pgp.net)
"To err is human -- to blame it on a computer is even more so."
