Oh god, you are right, i known it was a stupid things, thanks a lot, tomorrow i'll try to change my conf Mattia
Il mar 15 mag 2018, 00:02 Mikhail Mayorov <[email protected]> ha scritto: > Hi Mattia! > > It isn't kernel protocol. Use direct proto for import local connected > network. > > protocol direct { > > > > ipv4 { > > > > import all; > > > > export none; > > > > }; > > > > ipv6 { > > > > import all; > > > > export none; > > > > }; > > > > }; > > > > > 14.05.2018 23:58, Mattia Milani пишет: > > Hello all, i'm having a little problem, (Probabily is somthing so > > stupid) but i can't find the solution. > > > > I have this conf file: > > > > log "logTwo.log" all; > > router id 10.0.2.15; > > > > protocol kernel { > > metric 0; > > ipv4{ > > import all; > > export all; > > }; > > } > > > > protocol device { > > } > > > > protocol direct { > > interface "lo"; > > } > > > > > > The pourpose of the deamon that i need is simple, read the route address > > that i put in the "lo" interface and put it with the route of the deamon. > > > > i run the conf file with no error. > > Then i add a route in the lo interface, for example with this command: > > > > ip a add 192.168.4.0/24 <http://192.168.4.0/24> dev lo > > > > and if i check the address with the commadn "ip addr" i can see it in > > the lo interface. > > > > but if i run the command: > > > > birdc show route all > > > > I cannot see the new route address that i just addedd in the "lo" > interface > > > > How can i do that? > > > > Thanks to everyone that could help me, it will be so apreciated. > > > > Mattia > > -- > Regards, > Mikhail V. Majorov > > Megalink Company, Director of engineering > 318, Chehova street, Taganrog, Russia, 347932 > tel work: +7 8634 431431 (ext 101) > tel mobile: +7 918 5565520 > sip: [email protected] > www.tagan.ru >
