On Wed, Sep 14, 2011 at 10:35:58AM -0600, Hearns, John wrote: > Thinking about this, > would vacuforming not be a good option?
Alternately, try "smash molding". Short story: heat the plastic and pull it over a form. Make a clamp fixture that holds the edges of the plastic on all sides. Arrange the mold in a another fixture so it sits above (stands proud of) the fixture. Heat the plastic until plastic deformation starts. then pull it down over the mold, well past the bottom of the mold. -- David N. Lombard, Intel, Irvine, CA I do not speak for Intel Corporation; all comments are strictly my own. _______________________________________________ Beowulf mailing list, Beowulf@beowulf.org sponsored by Penguin Computing To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
