On Tue, Jul 21, 2009 at 15:42, Bill Broadley<b...@cse.ucdavis.edu> wrote: > > I'd suggest doing a visual inspection. Make sure all fans are not blocked by > cables, are spinning. If that looks normal pull the CPU heat sinks and make > sure they have good coverage with the heat sink goo, but not so much that it > leaks over the edge of the chip. When you put the heat sink back on make sure > the heat sink mount works as intended, especially on the (mostly intel?) 4 > post system where an unclicked post can result in unevent heat sink pressure. > > Be careful, fans moving != spinning. I've seen some that just vibrate enough > to look like they are spinning at a casual glance and are actually not moving > much air and are contributing a fair bit of heat to the system (I.e. very hot > to the touch).
Use the thin end of a zip tie to slowly interrupt and stop each fan while it is spinning. The pitch of the sound it makes will make a (very) rough comparison of the RPM, even in a noisy room. It will be obvious if it's turning normally or not. You might find one blowing backwards. Don't forget about double-rotor fans. > If that looks normal then I'd start swapping parts till you find the heat > sensitive one. He might swap his desk with that overheating node to help balance out the heat load... Or use something more intense than Memtest in your office. Try ACT Breakin. Once it's booted all the way, a machine with a heatsink ajar is usually powered off from thermal protection in < 5 seconds. Even in an ice cold room Try swapping it's power supply with another node that doesn't power off. P.S. And please do not spray liquid spray air upside down at hot computer components. _______________________________________________ Beowulf mailing list, Beowulf@beowulf.org sponsored by Penguin Computing To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
