Nifty niftyompi Mitch <[EMAIL PROTECTED]> writes: > Which driver is active? Which Infinipath software release > is installed? The tool "ipath_control -i" can show which...
QLogic kernel.org driver 00: Version: Driver 2.0, InfiniPath_QLE7140, InfiniPath1 4.2, PCI 2, SW Compat 2 I think this is a 2.1 distribution, whereas there's at least 2.2 now available. > The kernel.org/ofed driver does not have as rich a set of error recovery > code for this card as the shipped driver. The recovery code was seen > as a badness and not accepted by the kernel.org folk.... Hmm... > With a kernel update the driver will not have been recompiled > and the kernel.org driver would become active. [Actually it wasn't just a kernel update -- the SuSE 9.3 system disk was removed and replaced by a 10.3 one shortly after I arrived, trashing all the configuration, so I'm a little at sea, without infiniband experience.] > Look for this stuff in the Install Guide. > > # To rebuild the drivers, do the following (as root): > # cd /usr/src/infinipath/drivers > # ./make-install.sh > # /etc/init.d/infinipath restart I didn't realize that there's a driver significantly different from the kernel.org one, and haven't had time to read up enough. I'll give it a go when we can restart the relevant nodes. Many thanks for the info. _______________________________________________ Beowulf mailing list, Beowulf@beowulf.org To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
