Sangamesh, If it turns out that you need to recompile with the debugging symbol table, and then use a symbolic debugger to examine the "core" file against the application source, and you've never done that before, then drop me a line (but I would not be up-to-date about your compiler or your debugger). However, we are hoping someone has a better, easier response for you :-) Good luck, Peter
On Jan 30, 2008 11:03 AM, Sangamesh B <[EMAIL PROTECTED]> wrote: > Hi CPMD users, > > With a CPMD parallel job, I'm getting a Segmentation Fault error. > > Let me explain what I did. > > Installed MPICH with Intel Compilers. Configure looks as follows: > > ./configure --prefix=/opt/MPI_LIBS/MPICH-Intel > -cc=/opt/intel/cce/10.1.008/bin/icc > -fc=/opt/intel/fce/10.1.008/bin/ifort --enable-f77 --with-device=ch_p4 > --with-arch=LINUX > > > When I run a CPMD job with 1-4 proceses, the job is getting killed and > gives following error: > > # mpirun -machinefile /export/M4 -np 4 ./cpmd.x > /opt/APPLICATIONS/CPMD/singlemo l.input > single4.out > Killed by signal 2. > forrtl: error (69): process interrupted (SIGINT) > Killed by signal 2. > Killed by signal 2. > > If only one process is used and without redirection, the following error > occurred: > > p0_16857: p4_error: interrupt SIGSEGV: 11 > > Can anybody explain what might be the cause for this? > > regards, > Sangamesh > > > > > _______________________________________________ > Beowulf mailing list, Beowulf@beowulf.org > To change your subscription (digest mode or unsubscribe) visit > http://www.beowulf.org/mailman/listinfo/beowulf > >
_______________________________________________ Beowulf mailing list, Beowulf@beowulf.org To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
