Hello,
I have been trying to produce some Compatibility Layer actions for the AI
from
https://deepaklorkhatri.me/GSoC2020_BeagleBoard.org/2020/07/19/installing-compatibility-layer/.
I seem to be killing the board off each time I perform those actions. Is
anyone else using the AI for older source to make older repos. work that
were intentionally used for the BBB, BBBW, and so on?
I am asking b/c I have not yet figured out how to perform these actions w/
ease, success, or at all.
Seth
P.S. When, on the page listed above after a fresh install of a new image
for my AI, I get stuck here:
sudo cp src/arm/am5729-beagleboneai.dtb /boot/dtbs/4.19*/
That line ends up w/ an error on my end stating *am5729-beagleboneai.dtb
*cannot
be found. I reboot and the board seems to not boot. I will update the image
again. I was using kernel 4.14.x stock w/out updating the kernel from w/in
the AI. I will update to 4.19.x to test and return service. If you have any
ideas, please post at will.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/beagleboard/ac272747-c758-4ce9-bd1f-84be5cfef2bcn%40googlegroups.com.
