FYI I do not have an oscilloscope so I have just been testing pin 15 with a multimeter and I also just have an led on a breadboard, to test if a signal is coming from the pwm on pin 15.
On Saturday, August 8, 2020 at 12:57:15 PM UTC-7, M wrote: > > Can anyone provide a C program that can be run in CCS that would program > an I2C controller on the BBB board to generate the desired clock frequency > signal and the required data signals on the I2C bus. > > > Part 1. Program the device to generate signals to turn LED15 to full ON. > Should be measurable voltage from the number 15 signal pin on the servo > board. > > Part 2. Develop commands you send to PCA9685 to intialize it for the > correct frequency for your servo, set up a timer on the BBB to control > delays, and intialize the BBB User LEDs. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/533def37-f79d-416a-9aef-4f2056685c54o%40googlegroups.com.
