-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of Samuel Park
Sent: Saturday, August 08, 2020 3:04 PM
To: BeagleBoard <[email protected]>
Subject: RE: [beagleboard] Re: Project based off the Pocket Beagle - Boot
Configuration Help
Ah I see thanks for the reply. However the problem I have is that I removed all
the external pins including pins for power. Is there a way to set up a serial
connection via the USB 2.0 interface?
[Graham Stott] Yes, except that it would require a software driver which makes
the USB a virtual UART. So that does not help you at all.
I presume you do not have access to any of the OSD335x pads. You may need your
experience friend to redo the board and bring out the UART0 TX and RX to pads
that you could solder on some wires to connect to the
FTDI FT232 USB to UART Converter.
I am not sure what else to suggest.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/beagleboard/b52ea67a-32dd-4eb6-9004-3caeb490274co%40googlegroups.com.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/beagleboard/000301d66ddf%24d287ad50%24779707f0%24%40comcast.net.
