On Thu, Mar 12, 2020 at 8:14 AM John Hammond <[email protected]> wrote:
> The Y and Z steppers rotate but the X one does not. I have switched the > Polulu driver from the X to Z and it works fine. Where is the pulse rate > determined in Linux? Does Machinekit have linuxcnc files that I haven’t > seen? Should this be posted on Machinekit forum somewhere? Folks on the Machinekit forum would be better at those details, but... if you are seeing twitching, could it be as simple as that axis has too much resistance? There certainly is a config file to specify the pins for pulse/direction. You used a standard CRAMPS board, right? Who built it and can you verify the connection? Any logs to share? > Thanks, > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/4a0a7edd-bb08-494f-84d4-9a9b278f3733%40googlegroups.com > . > -- https://beagleboard.org/about - a 501c3 non-profit educating around open hardware computing -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CA%2BT6QP%3DLbh4aSLa31z5a9QhPpqwNWHZe869yYd9hbFKMxQJ8TQ%40mail.gmail.com.
