Hello, I tried to enable 1-wire, but did not found some paths .. maybe my installation is different?
I´m not sure what you need, so I write what I did so far: */boot/uEnv.txt:* #Docs: http://elinux.org/Beagleboard:U-boot_partitioning_layout_2.0 uname_r=4.9.82-ti-r102 #uuid= #dtb= ###U-Boot Overlays### ###Documentation: http://elinux.org/Beagleboard:BeagleBoneBlack_Debian#U-Boot_Overlays ###Master Enable enable_uboot_overlays=1 ### ###Overide capes with eeprom uboot_overlay_addr0=/lib/firmware/BB-UART1-00A0.dtbo uboot_overlay_addr1=/lib/firmware/BB-UART4-00A0.dtbo uboot_overlay_addr2=/lib/firmware/BB-W1-P9.12-00A0.dtbo ###Cape Universal Enable enable_uboot_cape_universal=1 ### ###U-Boot Overlays### cape_disable=bone_capemgr.disable_partno=BB-BONELT-HDMI,BB-BONELT-HDMIN cape_enable=bone_capemgr.enable_partno=BB-UART1,BB-UART4 cmdline=coherent_pool=1M net.ifnames=0 quiet I connect P9.12 to the 1-wires ... also GND and VCC (5V) the first issue: I don´t have this folder. */sys/devices/bone_capemgr.9/slots* Did this mean I have a different version? But I have this folder: */sys/devices/w1_bus_master1/* So the 1-wire is loaded and working? I added: */etc/modules* w1-gpio w1-therm But no sensor is found: *cat /sys/devices/w1_bus_master1/w1_master_slaves* not found. I appreciate for help! -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/c169a7ba-37f0-45ec-8e55-3226dc50093c%40googlegroups.com.
