hello i need adv7403.c and adv7403_regs.h ,adv7403linux driver you can send me?? thanks
On Thursday, May 17, 2012 at 10:08:26 PM UTC-7, shravan kulkarni wrote: > > Hi, > I have a Beagleboard-xM RevC to which DVSDK-4.01 is ported and runs > Linux Angstrom on it. To this board i have to interface a custom made board > built using ADV7403. ADV7403 interact with the Beagleboard via the camera > connector port which is there on the beagleboard. > > Input to ADV7403 is a RGB signal and the output of ADV7403 is 4:2:2 10-bit > YCbCr. now the beagleboard has to process this YCbCr and store into a > digital format. > > ADV7403 is programmed via I2C and im able to configure ADV7403 to my > requirement using i2cget and i2cset commands from the terminal. Now i have > the YCbCr signals at the > camera port of the Beagleboard but Beagleboard is not able to detect these > signals. when i check the devices detected for video it lists out > /dev/video1 and /dev/video2. but these are listed even when i dont connect > my ADV7403. This leads to the conclusion that ADV7403 might not be getting > detected by the Beagleboard. > > 1. How do i make the beagleboard to detect my adv7403 which is connected > to its camera connector. > > 2. As i can configure the ADV7403 to process RGB signal and give out > YCbCr, can i make the beagleboard to process this YCbCr by using any > application or by using any command. If the answer is yes then how to do > it..?? > > if i have missed out any information which is needed please mention it. > > > thanking you, > Shravan Kulkarni > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/06df9572-a3e2-420f-a217-09af0a5f4689%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
