Wow Dan! This is perfect. I was looking for something like this.
Did you create the Hirose header footprints yourself? They are very nice. Calvin On Wed, 12 Jun 2019 at 09:18, Daniel Block <[email protected]> wrote: > I thought I would post this to the BB x15 group in case some else would > find this board helpful. I created this board in EagleCAD 7. It breaks > out most of the PINs of the 4 expansion connectors of the BBx15. Hopefully > the schematic is documented enough that you can solder up the board > yourself. If you want to use the board to just break out the expansion > connectors you do not need to solder any of the chips except for the 7 > SN74CBTD16211DL chips that are level converters that would allow 5V > signals. > > Dan > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/37a0a372-58db-4fb0-8c0b-c15b9e66bb36%40googlegroups.com > <https://groups.google.com/d/msgid/beagleboard/37a0a372-58db-4fb0-8c0b-c15b9e66bb36%40googlegroups.com?utm_medium=email&utm_source=footer> > . > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAN%2BNdyi13jbYrXbtNNmu7S284cXowxaaczVUsVxCsZ_wX9gctQ%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
