Thank you for the reply! So far,* pruio_pwm_setValue()* with a non-zero frequency and zero duty cycle definitely seems like the most stable way to stop a PWM signal.
Don On Thu, Mar 14, 2019 at 12:42 PM TJF <[email protected]> wrote: > Hi Don! > > Am Mittwoch, 13. März 2019 21:49:06 UTC+1 schrieb Don Pancoe: >> >> Using *pruio_gpio_setValue()* to set a value of zero seems to do the >> trick, but I'd still be curious to know if there is an "official" way to do >> this. >> > > Setting the duty cycle to zero is the official way to switch off PWM > output. (Note: switching off by setting the frequency to zero would be > dangerous, since it will set the frequency for both outputs A and B in case > of output generated by a PWMSS subsystem. That's why such a feature isn't > implement.) > > Regards > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/b33823ba-e93b-494e-8a5d-f814def919d2%40googlegroups.com > <https://groups.google.com/d/msgid/beagleboard/b33823ba-e93b-494e-8a5d-f814def919d2%40googlegroups.com?utm_medium=email&utm_source=footer> > . > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAP3tSUN2Qn7nr-k4TyMpwfLbf%2BdxeWWRUZkEP8LmLgXJp0hYgQ%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
