Hello Again, Did you try sudo instead of just connmanctl? If so, I am at a standstill. I have to use sudo connmanctl to run my set-up for the WiFi.
Seth P.S. If you try a newer version of the listed images, I am sure it will work. You can *skip* the wifi enable and wifi scan if you use the newer images. You can start with services and agent on. On Saturday, July 8, 2017 at 3:23:11 PM UTC-5, Gokhan Aykan wrote: > > As U stated in my case, it cannot see any wifi device. > > So when i type wifi enable I get : > > Method "SetProperty" with signature "sv" on interface > "net.connman.Technology" doesn't exist > > I know the commands. But it cannot detect wifi. > > So have a problem in linux. > Regards > > On Sat, 8 Jul 2017 05:14 Mala Dies, <[email protected] <javascript:>> > wrote: > >> Hey Again, >> >> I am using an image from >> http://elinux.org/Beagleboard:BeagleBoneBlack_Debian. The flasher image >> called Stretch is what I used. I did not need to type, and this is after >> *sudo >> connmanctl* is entered in the prompt, *wifi enable* or *wifi scan*. >> >> Seth >> >> P.S. Get back to me. I may be able to help you. >> >> >> On Thursday, July 6, 2017 at 10:40:30 AM UTC-5, [email protected] wrote: >>> >>> Hi, >>> >>> I cannot enable wifi using *connmanctl.* >>> >>> *connmanctl** can ot recognize wlan, *only shows ethernet when >>> technologies is asked. >>> May I ask you which image are you using ? >>> >>> Gokhan >>> >>> >>> On Saturday, April 8, 2017 at 7:02:44 AM UTC+3, Mala Dies wrote: >>>> >>>> Hey Yo, >>>> >>>> *connmanctl *is used as the initial command from >>>> https://01.org/connman/documentation. >>>> >>>> Then, you have to type in, while under the command connmanctl, *wifi >>>> enable*. While still under the connmanctl command, type in *wifi scan* >>>> and then type *services*. It will show your *wifi_blah, blah, blah, >>>> blah, blah_blah, blah, blah_managed_psk *Wifi address to type in once >>>> you type *agent on* and then *connect*. So you would type this under >>>> connmanctl: >>>> >>>> wifi enable >>>> >>>> wifi scan >>>> >>>> services >>>> >>>> agent on >>>> >>>> connect wifi_<foo>_<foo>_managed_psk >>>> >>>> then... >>>> >>>> You will be asked for a password. Enter the password you have for your >>>> router. >>>> >>>> Done! I was taught this earlier today. >>>> >>>> Seth >>>> >>>> P.S. Enjoy! >>>> >>>> On Friday, April 7, 2017 at 8:18:00 PM UTC-5, Mala Dies wrote: >>>>> >>>>> Hello, >>>>> >>>>> I am using connmanctl to "try" to get into a valid configuration for >>>>> WiFi for a BBBW. I am not successful yet. Does anyone have any pointers? >>>>> >>>>> Seth >>>>> >>>> -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/7f36bafa-b8f0-49ca-8913-3a75992fdfb6%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
