Hi folks I hope that I am posting to the correct group.... apologies if this is the wrong place. We are creating a system based on the beagleboard black. We would like to implement a "Factory Reset". i.e. if I hold down a switch for a long period of time, say around 10 seconds, then we want to completely reset the system. Essentially the Reset pin is tied to one of the GPIO pins. So the GPIO follows the Reset pin. We would like to detect if the GPIO pin is still low about 10 seconds after the Reset has been asserted. The issue is that this is the time when the system is still booting up. I am not sure how one could check on the status of the pin during the boot up. Any ideas? Thanks a lot Rao
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/8dac92bb-1d9e-462b-8955-11bfc00f7706%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
