Hi Everyone, I am using a beagleboard-xm rev A3, I am trying to access the gpio pins of expansion connector via /sys/class/gpio/gpio130 but when i am setting the direction as out and value as 1 then i am not getting any output through that pin. I tried to access gpio4 the user switch but when i am pressing that switch i am not getting 1 in the value file.
So whats going wrong in my case. Your comments will be helpful to me. Thanks Anuj -- This message contains confidential information and is intended only for the individual(s) named. If you are not the intended recipient, you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this mail and attached file/s is strictly prohibited. Please notify the sender immediately and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secured or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/62566661-2f6e-4174-9f3b-7c213b4214dd%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
