On Wed, Sep 3, 2014 at 2:29 AM, Michael M <[email protected]> wrote:
> The frequency of your data(based on your sample) doesn't necessarily > require a 115kbps transmission rate. Good point. People from 3D printing word normally use 250Kbps because this is fast and has lower error rate than 115Kbps for the crystal frequency used on Arduinos. Although this data rate is not standard, newer kernels and python support it very well. Sure that 3D Printers need faster communication so 9600 is out of question that leads to choose non standard data rates. It is more likely that Chris application will work well on 9600bps. regards, Benito -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
