Woohoo! Success! You rule, thank you so much. install-me.sh worked some magic, then all I had to do was plug in the UWN200 and it worked. I had previously set up ra0 in /etc/network/interfaces with my wpa-psk.
Everything is good now, thanks again! -Zach On Tue, Jun 10, 2014 at 5:52 PM, Robert Nelson <[email protected]> wrote: > On Tue, Jun 10, 2014 at 5:23 PM, Zach Cox <[email protected]> wrote: >>> Laughs, so we had setup that initial debian image to work with UWN200 >>> out of the box. >> >> Yeah I know :) and it did work on that debian after a few simple >> commands, but I need Ubuntu 13.04 specifically for ROS. >> >>> Sure, we can make 13.04 work too.. So the question, who's 13.04 are you >>> using? >> >> I believe I'm using your 13.04, here are the instructions I followed >> to successfully flash 13.04 to the emmc: >> >> http://avedo.net/653/flashing-ubuntu-13-04-or-debian-wheezy-to-the-beaglebone-black-emmc/ >> >> http://elinux.org/Beagleboard:Ubuntu_On_BeagleBone_Black > > Well, we will see how "old" that is.. > > First, check that a "/etc/rcn-ee.conf" exists.. > > If it does, add: > > third_party_modules=enable > > If it's not, > > echo "distro=Ubuntu" > /tmp/rcn-ee.conf > echo "deb_distribution=Ubuntu" >> /tmp/rcn-ee.conf > echo "third_party_modules=enable" >> /tmp/rcn-ee.conf > sudo mv /tmp/rcn-ee.conf /etc/rcn-ee.conf > > Then run: > > wget http://rcn-ee.net/deb/raring-armhf/v3.8.13-bone56/install-me.sh > sudo /bin/bash install-me.sh > > Regards, > > -- > Robert Nelson > http://www.rcn-ee.com/ > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to a topic in the Google > Groups "BeagleBoard" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/beagleboard/Pb7xJhRAV3E/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/d/optout. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
