i am also getting same error. How to resolve this issue ? On Tuesday, May 20, 2014 12:15:55 AM UTC+5:30, [email protected] wrote: > > Did you ever figure this one out? I have a BBB that does the exact same > thing. > > On Wednesday, December 11, 2013 9:55:20 PM UTC-5, Gerald wrote: >> >> Does the board boot from the eMMC? >> >> Gerald >> >> >> >> On Wed, Dec 11, 2013 at 8:52 PM, <[email protected]> wrote: >> >>> I have been using my BBB rev A5 without any problems. >>> Today I received my new rev A6 BBB. I went to perform the upgrade like i >>> did with the A5 using the SD card. However on the A6 its does not work. I >>> get the following at the terminal on rev A6 with the same sd card that i >>> just upgraded the A5 with. >>> >>> U-Boot SPL 2013.04-dirty (Jun 19 2013 - 09:57:14) >>> musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, >>> SoftConn) >>> musb-hdrc: MHDRC RTL version 2.0 >>> musb-hdrc: setup fifo_mode 4 >>> musb-hdrc: 28/31 max ep, 16384/16384 memory >>> USB Peripheral mode controller at 47401000 using PIO, IRQ 0 >>> musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, >>> SoftConn) >>> musb-hdrc: MHDRC RTL version 2.0 >>> musb-hdrc: setup fifo_mode 4 >>> musb-hdrc: 28/31 max ep, 16384/16384 memory >>> USB Host mode controller at 47401800 using PIO, IRQ 0 >>> OMAP SD/MMC: 0 >>> ** Partition 1 not valid on device 0 ** >>> spl: fat register err - -1 >>> ### ERROR ### Please RESET the board ### >>> >>> >>> >>> I am using BBB-eMMC-flasher-2013.09.04.img >>> I have even tried taking the same image file and using Win32DiskImager >>> again on the A6 board, but i get the same results. >>> >>> Any ideas ?? >>> >>> >>> >>> >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/groups/opt_out. >>> >> >>
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
