On Saturday, May 25, 2013 7:30:46 AM UTC+8, Gerald wrote: > > You could ground the boot pin on the expansion connector until SYS_RESET > goes hi. > You could delete the MLO file from the eMMC. > You could erase the eMMC. > > Gerald > > > On Fri, May 24, 2013 at 5:30 PM, <[email protected] <javascript:>>wrote: > >> Hello all, >> >> I would like to use GPMC on the BBB board, but as it states on the system >> reference manual >> >> "GPMC bus may NOT be available due to the use of those signals by the >> eMMC" >> >> Then it suggests to use the SD boot mode and not the eMMC. >> >> My question is, how can I have the board to boot from the SD card rather >> than the eMMC. >> >> Help would be appreciated! >> >> Jack >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> >> >> > > > > -- > Gerald > > [email protected] <javascript:> > [email protected] <javascript:> > http://beagleboard.org/ > http://circuitco.com/support/ >
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
