On Wed, Feb 19, 2014 at 11:48 AM, <[email protected]> wrote: > hello > > I am trying to use the gpio of bbxm. > > I follow the step of this link: > http://elinux.org/BeagleBoardUbuntu#BeagleBoard_xM > using the prebuilt image. > > I can boot the board successfully. > However, I encounter a problem that even i try to set the gpio pin 139 to > "low" it still output 1.8V. > But I can successfully control it with Angsrom system.(With the same > command.) > > Is there any one can help me?Thanks! > > Did you update the *.dtb file for your board to setup that pin as a gpio?
You can't really compare the ancient Angstrom (board file) kernel with this.. Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
