On 03/12/2018 04:18 PM, Heitor Faria wrote:
> Dear Bacula Users,
>
> For several years I've noticed that %f is not working for Run Job script.
> E.g.:
>
> - ClientRunAfterJob = "/etc/bacula/scripts/monit.sh %i %c %n %f %s %b %e"
>
> Output:
>
> - 136 hfaria-asus-i5-fd BackupClient1 %f *none* 0 OK
>
> Am I doing something wrong?
Hi Heitor!
Only thing you are doing is using an older version. :)
This bug was actually semi-recently fixed. I cannot seem to find when it was
fixed, but I know I am using it daily in the AutoRestoreAndVerify.sh script I
had released to this list last year.
BTW, I am on 9.0.5, so this has been working since at this this time and this
version.
BUT.... I use the new RunScript syntax:
For example:
----8<----
RunScript {
RunsWhen = after
RunsOnClient = no
RunsOnFailure = no
# Call _this_ script and pass the current backup job's jobid,
# client, jobname, and fileset
-------------------------------------------------------------------------
Command = "/etc/bacula/scripts/AutoRestoreAndVerify.sh %i %c %n %f"
}
}
----8<----
Can you check your version and let me know if this Syntax works, while the
older ClientRunAfterJob does not?
Thank you!
Best regards,
Bill
--
Bill Arlofski
http://www.revpol.com/bacula
-- Not responsible for anything below this line --
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
