Hi all,
I am using a Tape library with two drives. Both are set up in the sd.conf.
What can I do to run Backupjobs on both drives at the same time?
At the Moment only one drive (/dev/nst0) is used.
I am using Bacula 2.4.4.
This is the status output:
Device status:
Autochanger "Autochanger" with devices:
"Drive-1" (/dev/nst0)
"Drive-2" (/dev/nst1)
Device "Drive-1" (/dev/nst0) is mounted with:
Volume: MBB065
Pool: *unknown*
Media type: IBM-LTO4
Slot 27 is loaded in drive 0.
Total Bytes Read=0 Blocks Read=0 Bytes/block=0
Positioned at File=0 Block=0
Device "Drive-2" (/dev/nst1) is not open.
Drive 1 status unknown.
====
Used Volume status:
MBB065 on device "Drive-1" (/dev/nst0)
Reader=0 writers=0 devres=0 volinuse=0
Regards,
Stefan Lubitz
Head of IT Stuttgart - Munich - Detroit
_________________________________________________________
MACKEVISION
Medien Design GmbH, Stuttgart
Forststraße 7
D - 70174 Stuttgart
Tel.: +49 (0) 711 / 933 048-98
Fax.: +49 (0) 711 / 933 048-90
[email protected]<mailto:[email protected]>
www.mackevision.de<http://www.mackevision.de>
Geschäftsführer: Armin Pohl, Joachim Lincke
HRB 243735 Amtsgericht Stuttgart
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:
Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
