Bob Hetzel wrote:
>> => *update slots
>> => Automatically selected Storage: Dell-PV136T
>> => Enter autochanger drive[0]: 0
>> => Connecting to Storage daemon Dell-PV136T at gyrus:9103 ...
>> => 3306 Issuing autochanger "slots" command.
>> => Device "Dell-PV136T" has 0 slots.
>> => No slots in changer to scan.
>> ^^^^^^^^^^^^^^^^^^^^^^^^^^^
>>
>> I often see this if I do something like add/remove/move tapes outside of
>> bacula, using mtx or the front-panel controls of the tape drive. The only
>> reliable way to address the tape drive after this is to restart bacula.
>>
>
> Yup. I in fact did take the library offline to add tapes. Has anybody
> found a method of tape rotation in and out of the library that doesn't
> involve shutting bacula down? This is kind of a big deal as most backup.
I have the same library here, and I've often added and removed tapes without
shutting down the sd - you just have to make sure that no jobs are running,
and bacula has unmounted the volumes.
Also note that the library sometimes takes a little while to wake back up
after it's been offline, so you may have to repeat update slots once or twice
before it will admit that it's there.
--
Frank Sweetser fs at wpi.edu | For every problem, there is a solution that
WPI Senior Network Engineer | is simple, elegant, and wrong. - HL Mencken
GPG fingerprint = 6174 1257 129E 0D21 D8D4 E8A3 8E39 29E3 E2E8 8CEC
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
