I have a Sipura 3000 ATA I am testing as a PSTN gateway, I have little
interest in the fxs port, lthough the failover is cool
I upgraded to the latest firmware. I used the wazard on Voxilla to configure
the unit. Incoming works fine.
When I dial out, the dial string is sent to the unit:
-- Executing Dial("SIP/1001-9e54", "SIP/[EMAIL PROTECTED]|60|") in new
stack
-- Called [EMAIL PROTECTED]
-- SIP/pstn-spa3k-5a70 is ringing
-- SIP/pstn-spa3k-5a70 answered SIP/1001-9e54
-- Attempting native bridge of SIP/1001-9e54 and SIP/pstn-spa3k-5a70
But all I get, after a few seconds, is a busy signal. I know the line is not
busy, the number I am dialing is available, and I have tested the line with
a handset.
[pstn-spa3k]
type=peer
auth=md5
host=192.168.0.14
port=5061
secret=mysecret
username=asterisk
fromuser=asterisk
dtmfmode=rfc2833
; If using [EMAIL PROTECTED], change the below line to context=from-internal
context=internal
insecure=very
Any ideas?
Chris Mason
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
