Do you have your zaptel drivers set to start when the system is rebooted? If not, try rebooting and issue the "modprobe zaptel" and "modprobe wctdm" commands to manually start them. You could also issue the "lsmod" command after a reboot to see if zaptel and wctdm are running. I had problems with the zaptel startup script, but for whatever reason it works now.
Good luck! Mark -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Sunday, January 16, 2005 7:38 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: [Asterisk-Users] TDM400 lost after reboot Hi My card is working, but when I reboot the machine, most of the times it is not working, I get "ztcfg: ZT_CHANCONFIG failed on channel 1: No such device or address (6)" To make it work again I have to shut down, remove the card, reboot so kudzu will remove the config. shut down again, put the card back in, reboot, now kudzu see it, I choose "Ignore" and then it's working again (until the next reboot). I'm on WBEL 3.0 and the card is not sharing is IRQ. Is anybody else having this problem ? When kudzu see it (as a Jens Schoenfeld Intel 537), what should I choose ? Is there something I can do to prevent this from happening ? Thanks _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
